ElectraLoop Scrotal Loop: Fit and Adjustment Guide
By ElectraStim- Electro Sex Products- Official Store | Published: 2026-10-17
Category: How-to Guides
Learn how to fit and adjust the ElectraLoop Adjustable Metallic Scrotal Loop for comfortable electro play. Step-by-step instructions and common mistakes to avoid.
Quick Answer
To fit the ElectraLoop Adjustable Metallic Scrotal Loop, slide the non-stretch coil over your penis and behind your testicles, then adjust the choke for a snug but not tight fit. The metallic coil delivers electro stimulation to your scrotum while the adjustable design lets you customize the circumference for comfort.
Understanding the ElectraLoop Design
The ElectraLoop Adjustable Metallic Scrotal Loop is made from a non-stretch metallic coil, giving it the feel of a metal cock ring with the comfort of an adjustable fit. Unlike fixed-size rings, you can loosen or tighten the loop by sliding the adjustment choke, making it suitable for thicker girths or those who prefer to wear the ring around both penis and testicles. The metallic construction conducts electro stimulation directly to the scrotal area, but the choke itself is insulated so the rubber loop receives all the power.
Before You Start: Safety and Preparation
Always clean the ElectraLoop with a mild antibacterial toy cleaner or warm water and soap before first use. Apply a generous amount of water-based conductive gel to the inside of the loop and to your scrotum—this ensures even electrical contact and prevents hot spots. Start with your electro stimulator on the lowest setting and increase gradually. Never use silicone-based lubricants with conductive rubber loops, as they can degrade the material.
Step-by-Step Fit and Adjustment Guide
- Step 1: Apply conductive gel: Coat the inside of the loop and your scrotum with water-based conductive gel. This is essential for even electrical contact and comfort. Common mistake: using too little gel causes uneven stimulation or sharp sensations. Reapply if needed.
- Step 2: Slide the loop over your penis: With the adjustment choke fully open (slide it toward the loose end), place the loop over the head of your penis and slide it down the shaft until it rests behind your testicles. Checkpoint: the loop should sit comfortably behind your balls, not pressing against the base of your penis.
- Step 3: Adjust the fit using the choke: Gently slide the adjustment choke to tighten the loop until it feels snug but not constricting. You should be able to slip a fingertip between the loop and your skin. Common mistake: overtightening can cut off circulation. If you feel numbness or tingling (beyond electro sensations), loosen immediately.
- Step 4: Connect your electro stimulator: Attach a unipolar cable from your electro stimulator to the connection point on the loop. Ensure the cable is securely snapped on before turning on the device. Checkpoint: always start at the lowest power level and increase slowly. If you feel sharp pinching, check gel coverage and cable connection.
- Step 5: Test and reposition: Move around gently to see if the loop stays in place. The non-stretch coil holds its shape, so you may need to adjust the choke slightly for different positions. Final tip: after your session, clean the loop with warm water and mild soap. Avoid abrasive cleaners that could damage the metallic coil finish.
Product Facts
- ElectraLoop Adjustable Metallic Scrotal Loop: For thicker girths and those who prefer to wear their cock rings around both their penis and testicles, this Metallic Electro Scrotal Loop has an adjustable design that provides the bigger size you need for play that incorporates your balls. Made from a non-stretch metallic coil, it has the feel of a metal cock ring with the comfort of an adjustable fit. The adjustable design means you can fine-tune the fit without buying multiple sizes, and the metallic coil delivers consistent electro stimulation across the scrotal area.
